It took me quite awhile to find one of these – almost 8 years. Fortunately a local member in the greater Toronto area had one and the kit only had 1,500km on it. This is the (now defunct) RSM kit. It includes the bracket, pulleys, belt, piping, silicone couplers, blow-off valve, and the supercharger. The […]
I have obtained all the parts needed to do the 7730 ECM swap and the DIS (distributor-less ignition system, ie: digital ignition). The 7730 ECM is far superior to the standard Fiero ECM. The 7730 ECM updates 10 times a second, while the Fiero ECM updates every 1.5 seconds. The main benefit from upgrading to […]
The trunk seal on my GT was torn badly near the engine. They tend to tear over time – in most cases they will rip if you are trying to remove them. A member on Pennock’s Fiero Forum is reproducing these – the quality is excellent.
Man cave build-up. AKA, the garage. I will let the pictures do the talking…
When replacing the EVAP purge valve (valve that re-circulates the gases in the gas tank) the embedded nuts in the canister rust-weld and fall right out – especially for those in a northern climate. To fix this, remove the embedded nuts entirely and go to your local automotive store to pick up a pair of […]
I was doing some measurements for a turbo installation. It’s been a while since I touched the engine bay, so I thought i’d post a picture of it’s current state.
I purchased this from a store in the Mississauga area. It is a bracket specifically designed for corner mounting a TV – it has two separate mount points. Quite well made – the metal is 1/8″ thick. In ordered to properly mount it, I used 2×10 to tie into the wall studs – the bracket […]