I have created the inner cut-outs on the main leg supports :)
Today I installed the driver’s side PISA door panel. It took about 2 hours and was quite easy. The only problem is that the interior armrest covers the HVAC vent on the dash. I will need to make a custom cut to the armrest – this should allow better airflow from the vent.
This was one of the easier installs I have done over the past year – no fabrication was required. This is the Fiero Store fiberglass headliner. I acquired this almost 4 years ago and it’s been sitting in my basement waiting to be installed. All the holes are pre-marked, so it was just a matter […]
I spent the last three hours adding additional support for the fiberglass center console – a.k.a. the armrest. It involved fabricating a metal bracket and a fiberglass ledge. I also mounted the shifter boot – this boot is just used as a mock-up. I have a nice Rodney Dickman leather boot that will take it’s […]